Mostra el registre d'ítem simple

Analysis of printing parameters for metal additive manufactured parts through Direct Ink Writing process

dc.contributor.authorBonada Bo, Jordi
dc.contributor.authorXuriguera Martin, Elena
dc.contributor.authorCalvo Duarte, Laura
dc.contributor.authorPoudelet, Louison
dc.contributor.authorCardona, Roger
dc.contributor.authorPadilla, Jose Antonio
dc.contributor.authorNiubó Eslava, Maria
dc.contributor.otherUniversitat Politècnica de Catalunya. Departament de Resistència de Materials i Estructures a l'Enginyeria
dc.contributor.otherUniversitat Politècnica de Catalunya. Departament d'Enginyeria Minera, Industrial i TIC
dc.date.accessioned2020-03-17T10:56:24Z
dc.date.available2020-03-17T10:56:24Z
dc.date.issued2020-03-09
dc.identifier.citationBonada, J. [et al.]. Analysis of printing parameters for metal additive manufactured parts through Direct Ink Writing process. "Procedia manufacturing", 9 Març 2020, vol. 41, p. 666-673.
dc.identifier.issn2351-9789
dc.identifier.urihttp://hdl.handle.net/2117/180173
dc.description.abstractDirect Ink Writing is an Additive Manufacturing process in which a metal ink is continuously extruded to built-up a green metal part. Therefore, a debinding and sintering process is required to obtain the final metal part. This thermal process produces a shrinkage of the green printed part according to several material and printing parameters. In this paper, the influence of printing process planning on the width of printed rods for a copper ink is analyzed by means of a Design of Experiments procedure to optimize the printing and equipment parameters and characterize the shrinkage after the sintering process
dc.format.extent8 p.
dc.language.isoeng
dc.subjectÀrees temàtiques de la UPC::Enginyeria dels materials
dc.subject.lcshMetals
dc.subject.lcshThree-dimensional printing
dc.subject.otherDirect Ink Writing
dc.subject.otherAdditive Manufacturing
dc.subject.otherPrinting process planning
dc.titleAnalysis of printing parameters for metal additive manufactured parts through Direct Ink Writing process
dc.typeArticle
dc.subject.lemacMetalls
dc.subject.lemacImpressió 3D
dc.contributor.groupUniversitat Politècnica de Catalunya. REMM - Recerca en Estructures i Mecànica de Materials
dc.identifier.doi10.1016/j.promfg.2019.09.056
dc.description.peerreviewedPeer Reviewed
dc.relation.publisherversionhttps://www.sciencedirect.com/science/article/pii/S2351978919311461
dc.rights.accessOpen Access
local.identifier.drac27256695
dc.description.versionPostprint (published version)
local.citation.authorBonada, J.; Xuriguera, E.; Calvo , L.; Poudelet, L.; Cardona, R.; Padilla, J.A.; Niubó, M.
local.citation.publicationNameProcedia manufacturing
local.citation.volume41
local.citation.startingPage666
local.citation.endingPage673


Fitxers d'aquest items

Thumbnail
Nom:
1-s2.0-S2351978919311461-main.pdf
Mida:
925,6Kb
Format:
PDF
Visualitza/Obre

Aquest ítem apareix a les col·leccions següents

Mostra el registre d'ítem simple