Effects of reinforcement details on behavior of drilled shaft footings
Visualitza/Obre
S-2022-071.R2_Proof_hi.pdf (2,627Mb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Cita com:
hdl:2117/384141
Tipus de documentArticle
Data publicació2023-01
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
This paper presents an experimental study on the structural behavior of reinforced concrete drilled shaft footings, also commonly referred to as pile caps, supported on four drilled shafts. The test program investigated the effects of three design parameters related to reinforcement detailing: layouts of bottom mat reinforcement (grid versus banded), anchorage details for bottom mat reinforcement (straight versus hooked bar), and ratios of side-face reinforcement to control shrinkage and temperature cracking. Seven large-scale drilled shaft footing specimens, each constructed with a center-located square column stub, were tested under uniform axial compression column loading. The specimens represent typical drilled shaft footings, which can generally be considered as three-dimensional (3-D) deep (D-region) elements. The test results indicate that the ultimate strengths of the footings were comparable when the bottom mat reinforcement was properly developed, regardless of the type of layouts and anchorage details. Nevertheless, different crack patterns were obtained for different bottom mat reinforcement layouts. The absence of side face reinforcement led to lower capacity and more brittle failure as compared to footings having a minimum amount of side-face reinforcement. Finally, some refinements are proposed to existing 3-D strut-and-tie modeling guidelines to more accurately reflect the ultimate strengths of the test specimens.
CitacióKim, H. [et al.]. Effects of reinforcement details on behavior of drilled shaft footings. "ACI structural journal", 2023, vol. 120, núm. 1, p. 285-301.
ISSN0889-3241
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
S-2022-071.R2_Proof_hi.pdf | 2,627Mb | Accés restringit |