Study on the formability and texture evolution of AA6061 alloy processed by repetitive corrugation and straightening
Visualitza/Obre
10.22201/icat.24486736e.2021.19.5.1588
Inclou dades d'ús des de 2022
Cita com:
hdl:2117/358678
Tipus de documentArticle
Data publicació2021-10-28
Condicions d'accésAccés obert
Llevat que s'hi indiqui el contrari, els
continguts d'aquesta obra estan subjectes a la llicència de Creative Commons
:
Reconeixement-NoComercial-SenseObraDerivada 3.0 Espanya
Abstract
The enhanced mechanical properties obtained by refining the grain size down to the ultrafine-grained (UFG) regime have attracted considerable attention in recent years. The severe plastic deformation (SPD) techniques allow obtaining ultrafine-grained materials. Different SPD techniques permit processing sheet shape materials such as repetitive corrugation and straightening (RCS) and accumulative roll bonding (ARB). In this study, the formability of an AA 6061-T6 processed by RCS was evaluated. The forming limit diagrams (FLD) were obtained by Nakazima tests of samples in initial condition (T6 state) and after one and two RCS cycles. The FLD curves showed that the forming capacity decreased from the first RCS cycle. Likewise, uniaxial tensile tests at different temperatures and strain rates were conducted to analyze the effect of the RCS process on the strain rate sensitivity. They showed a relatively high strain rate sensitivity coefficient in the samples after one and two RCS cycles, which indicates an improvement of i) the capacity of the material to delay the onset of the necking and ii) the formability at increasing temperatures. Finally, texture analysis was carried out employing X-ray diffraction, calculating the orientation distribution functions (ODFs). The initial texture showed a predominant cube texture component, whereas, for further RCS cycles, a weakening of the cube texture and an increment of the S texture component were observed.
CitacióElizalde, S. [et al.]. Study on the formability and texture evolution of AA6061 alloy processed by repetitive corrugation and straightening. "Journal of Applied Research and Technology", 28 Octubre 2021, vol. 19, núm. 5, p. 548-561.
ISSN1665-6423
Versió de l'editorhttps://jart.icat.unam.mx/index.php/jart/article/view/1588
Col·leccions
- CDAL - Centre de Disseny d'Aliatges Lleugers i Tractaments de Superfície - Articles de revista [27]
- Departament de Ciència i Enginyeria de Materials - Articles de revista [734]
- PROCOMAME - Processos de Conformació de Materials Metàl·lics - Articles de revista [259]
- Doctorat en Ciència i Enginyeria dels Materials - Articles de revista [156]
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
document.pdf | 2,459Mb | Visualitza/Obre |