Study of the manufacturing process effects of fused filament fabrication and injection molding on tensile properties of composite PLA-wood parts
Visualitza/Obre
Study_of_the_manufacturing_process_effects_of_fuse.pdf (2,628Mb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Cita com:
hdl:2117/189960
Tipus de documentArticle
Data publicació2020-05-30
Condicions d'accésAccés restringit per política de l'editorial
Llevat que s'hi indiqui el contrari, els
continguts d'aquesta obra estan subjectes a la llicència de Creative Commons
:
Reconeixement-NoComercial-SenseObraDerivada 3.0 Espanya
Abstract
The present study evaluates the effects of manufacturing parameters on the tensile properties of a commercial composite material based upon polylactic acid (PLA) with wood fibers known as Timberfill. The specimens are built through fused filament fabrication (FFF), and the influence of four printing parameters (layer height, fill density, printing velocity, and orientation) is considered through a L27 Taguchi orthogonal array. Tensile tests are applied to obtain the response variable used as output results to perform the ANOVA calculations. Results show that fill density is the most influential parameter on the tensile strength, followed by building orientation and layer height, whereas the printing velocity shows no significant influence. The optimal set of parameters and levels is found, being 75% fill density, 0¿Z-axis orientation, 0.4 mm layer height, and 40 mm/s velocity as the best combination. Applying this combination, a 9.37-MPa maximum strength is the highest value obtained for the material. Additionally, five solid injection molded Timberfill specimens were tested as well and the results compared with the FFF samples. The values of the elastic modulus, elastic limit, and maximum strength of the injected samples were almost twofold of those were obtained for the FFF samples, but the maximum elongation of the injected specimens fell sharply.
CitacióZandi, M. [et al.]. Study of the manufacturing process effects of fused filament fabrication and injection molding on tensile properties of composite PLA-wood parts. "International journal of advanced manufacturing technology", 30 Maig 2020, p. 1-11.
ISSN0268-3768
Versió de l'editorhttps://link.springer.com/article/10.1007%2Fs00170-020-05522-4
Col·leccions
- Departament d'Enginyeria mecànica - Articles de revista [594]
- Doctorat en Enginyeria Mecànica, Fluids i Aeronàutica - Articles de revista [145]
- Departament de Ciència i Enginyeria de Materials - Articles de revista [729]
- PROCOMAME - Processos de Conformació de Materials Metàl·lics - Articles de revista [259]
- TECNOFAB - Grup de Recerca en Tecnologies de Fabricació - Articles de revista [204]
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
Study_of_the_ma ... rocess_effects_of_fuse.pdf | 2,628Mb | Accés restringit |