The effect of die half angle in tube nosing with relieved die
Visualitza/Obre
Estadístiques de LA Referencia / Recolecta
Inclou dades d'ús des de 2022
Cita com:
hdl:2117/182198
Tipus de documentText en actes de congrés
Data publicació2013
EditorCIMNE
Condicions d'accésAccés obert
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
This research concentrates on rotary nosing using cone shape dies, in particular using “relieved dies”. “Relieved die” is a cone-shape die with contact surfaces and grounddown relieved surfaces. The objective of this research is to improve the forming limit by reducing the necessary force during the process. The present research focuses attention on the effect of die half angle. Die half angle is important parameter because the angle of nosing depends on the angle of the die in press and rotary nosing. According to the previous research, the forming limit is highest when the number of contact areas is three [1]. Therefore, this paper researched on the effect of die half angle by experiment and calculation, FEM, under the condition that the number of contact areas is three. It is revealed that the optimum contact angle changes depending on the die half angle.
ISBN978-84-941531-5-0
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
COMPLAS2013-05_The effect of die half.pdf | 1,156Mb | Visualitza/Obre |