Influence of the regime of electropulsing-assisted machining on the plastic deformation of the layer being cut
Visualitza/Obre
Cita com:
hdl:2117/117696
Tipus de documentArticle
Data publicació2018-05-25
Condicions d'accésAccés obert
Llevat que s'hi indiqui el contrari, els
continguts d'aquesta obra estan subjectes a la llicència de Creative Commons
:
Reconeixement 4.0 Internacional
Abstract
In this article, the influence of electropulsing on the machinability of steel S235 and aluminium 6060 has been studied during conventional and electropulsing-assisted turning processes. The machinability indices such as chip compression ratio ¿, shear plane angle f and specific cutting energy (SCE) are investigated by using different cutting parameters such as cutting speed, cutting feed and depth of cut during electrically-assisted turning process. The results and analysis of this work indicated that the electrically-assisted turning process improves the machinability of steel S235, whereas the machinability of aluminium 6060 gets worse. Finally, due to electropluses (EPs), the chip compression ratio ¿ increases with the increase in cutting speed during turning of aluminium 6060 and the SCE decreases during turning of steel S235.
CitacióHameed, S., Gonzalez-Rojas, Hernan A., Perat, J., Napoles, A., Sánchez, A. Influence of the regime of electropulsing-assisted machining on the plastic deformation of the layer being cut. "Materials", 25 Maig 2018, vol. 11, núm. 6, p. 886-1 - 886-10.
ISSN1996-1944
Versió de l'editorhttp://www.mdpi.com/1996-1944/11/6/886
Col·leccions
- Departament d'Enginyeria mecànica - Articles de revista [596]
- GAECE - Grup d'Accionaments Elèctrics amb Commutació Electrònica - Articles de revista [50]
- TECNOFAB - Grup de Recerca en Tecnologies de Fabricació - Articles de revista [206]
- Departament d'Enginyeria Elèctrica - Articles de revista [884]
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
materials-11-00886.pdf | Articulo original | 628,7Kb | Visualitza/Obre |