Influence of injection molding parameters on the morphology, mechanical and surface properties of ABS foams
Cita com:
hdl:2117/113910
Tipus de documentArticle
Data publicació2018-01-24
Condicions d'accésAccés obert
Llevat que s'hi indiqui el contrari, els
continguts d'aquesta obra estan subjectes a la llicència de Creative Commons
:
Reconeixement-NoComercial-SenseObraDerivada 3.0 Espanya
Abstract
In this work, microcellular ABS foams were studied. A series of injection molding samples defined by a design of experiments was carried out to analyze the effect of shot volume, mold temperature, and injection velocity on the morphology, mechanical properties, and surface roughness of microcellular samples. A predominant influence of shot volume on the cell structure and tensile properties was evidenced. Higher cell densities and narrower cell size distributions were obtained at lower injection volume. However, elastic modulus and tensile strength were improved by increasing the shot size. The effect of mold temperature and injection velocity was secondary. Higher levels of mold temperature and injection rate provided finer cell morphologies, but their effects on the elastic modulus and tensile strength were negligible. The decrease in shot volume and increase in gas content led to poor surface quality, whereas it was greatly improved by raising both mold temperature and injection velocity
CitacióGomez, J., Sanchez-Soto, M., Maspoch, M. Influence of injection molding parameters on the morphology, mechanical and surface properties of ABS foams. "Advances in polymer technology", 2018, vol. 37, núm. 8, p. 2707-2720
ISSN0730-6679
Versió de l'editorhttp://onlinelibrary.wiley.com/doi/10.1002/adv.21944/full
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
Gomez Monterde, ... roperties of ABS foams.pdf | 2,697Mb | Visualitza/Obre |