During the last century there has been a growing concern about water pollution throughout the developed countries. Water has a major impact on the environment as it is used by all living being. This leads to leave the ...

Prototyping or materialisation is an expensive stage of Product Design. In a lot of cases, the same technology is both used for the final product and test models; this makes the prototype units very expensive. The use of ...

[ANGLÈS] The two main objectives of this project are to analyse the efficiency of several techniques widely used among the field of emotion recognition through spoken audio signals, and, secondly, obtain empirical data ...

Solar energy is a renewable source with the greatest potential for sustainable energy production. Among modern energy societies, the use of heat and electricity predominates. Both energy carriers can be produced with ...

In order to improve our knowledge of the behaviour of Rivers Mountains and the risk associated to them, this TFM propose to study experimentally the morphodynamic behaviour of these rivers under avenue situation. The ...

An overview of one-way clutches, used design principles and criteria for selection was prepared. The main problem while designing an e-bike drive using a sprag clutch was the assembly tolerances. Therefore, an analysis ...

Novo Mesto is a small town in the Slovenian countryside which is undergoing a new project of road safety. New traffic signals are to be placed in bus stops to give drivers awareness of children standing waiting for the ...

Non-stoichiometric Heusler Ni-Mn-Ga based alloys with addition of up to 7,5 at.% of Cu were prepared. Homogenized alloys were characterized using polarized light microscopy, X-ray diffraction, differential scanning calorimetry ...

Within the master work the phenomenon of appearance of firecracks on the surface of the work rolls that occur during hot rolling of flat products in the case of regular rolling conditions and in the case of the rolling ...