Exploració per tema "Lenses"
Ara es mostren els items 1-20 de 21
-
An architecture analysis for millimeter-wave optically steerable antenna array
(Institute of Electrical and Electronics Engineers (IEEE), 2019)
Comunicació de congrés
Accés restringit per política de l'editorialA lens-based integrated photodiode-antenna array for a Radio over Fiber (RoF) 5G wireless base station at millimeter-wave frequencies is proposed and analyzed. The elements of the array are based on slot bow-tie antennas ... -
Assessment of LTCC-based dielectric flat lens antennas and switched-beam arrays for future 5G millimeter-wave communication systems
(2017-10-30)
Article
Accés obertIEEE This paper presents design, LTCC fabrication, and full experimental verification of novel dielectric flat lens antennas for future high data rate 5G wireless communication systems in the 60 GHz band. We introduce and ... -
Awareness of treatment: a source of bias in subjective grading of ocular complications
(Public Library of Science (PLOS), 2019-12-26)
Article
Accés obertPurpose: Bias has been described as one important obstacle in scientific research. The aim of this study was to explore “awareness of treatment” as a possible source of bias in subjective grading of ocular complications. ... -
Design of a dielectric flat lens antenna for 60 GHz WPAN applications
(Institute of Electrical and Electronics Engineers (IEEE), 2013)
Text en actes de congrés
Accés restringit per política de l'editorialIn this paper we present the design of a dielectric flat lens antenna to operate in the 60 GHz band for WPAN applications. In order to overcome the specific atmospheric attenuation, which characterizes the propagation in ... -
En el 350 aniversario del nacimiento de Anton Van Leeuwenhoek
(PUNTEX, 1983-12)
Article
Accés obert -
En el 350 aniversario del nacimiento de Antoni van Leeuwenhoek (y II). Su obra.
(PUNTEX, 1984-05)
Article
Accés obert -
Fabrication of microlens in polymers with thermal reflow
(Universitat Politècnica de Catalunya, 2012-09-12)
Projecte Final de Màster Oficial
Accés obert[ANGLÈS] This study shows that it is possible to fabricate lenses with a very small diameter by depositing and melting the photoresist layer on a glass substrate. Thermal Reflow technique has been used to melt the top ... -
How to establish an adequate system for eye lens dose monitoring: a proposal for typical workplaces
(2019-12-31)
Article
Accés restringit per política de l'editorialFor years, the dose limit of 150 mSv for occupational exposure of the lens of the eye to ionising radiation was rarely exceeded, and the dose to the eye was only monitored occasionally. With the national implementation of ... -
Image formation with lenses, pinholes and slits in an optical box
(Hands-on Science Network, 2023)
Comunicació de congrés
Accés restringit per política de l'editorialImages formed by systems with small apertures, such as pinholes and slits, have very weak illumination. It is advisable an object with a high luminance and with considerable size to see these images. Besides, the device ... -
Lents hologràfiques: funcionament i percepció
(Universitat Politècnica de Catalunya, 2020-06)
Treball Final de Grau
Accés obertLa tecnología de realitat virtual sempre ha tingut un futur incert des dels seus inicis. Als anys 50, la creació del Sensorama ja va demostrar l’ambició de l’espècie humana per endinsar-se en una realitat alternativa i, ... -
Matching layer design to improve the performance of an inhomogeneous dielectric flat lens at millimeter-wave frequencies
(Institute of Electrical and Electronics Engineers (IEEE), 2015)
Text en actes de congrés
Accés restringit per política de l'editorialIn this paper, the design of a matching layer to increase the maximum achievable gain, reduce the back-radiation, and enhance the bandwidth performance of a dielectric flat lens antenna for millimeter-wave applications is ... -
Montaje de lentes monofocales con biseladora automática
(2008-10-06)
Audiovisual
Accés obert -
OUFTI-NEXT : study of refractive lenses for an infrared camera
(Universitat Politècnica de Catalunya, 2019-05-22)
Projecte Final de Màster Oficial
Accés obert
Realitzat a/amb: Université de Liège / Centre Spatial de LiègeThe aim of this master thesis is to survey the capability of a refractive design to accommodate the requirements of the OUFTI-NEXT payload. The optical design for thermal infrared camera is challenging:• the lack of glass ... -
Parameter design of a biaxial lidar ceilometer
(2012-07-11)
Article
Accés restringit per política de l'editorialThis paper presents parameter design methodology and related optomechanical engineering of a 905-nm diode-laser biaxial, eye-safe lidar ceilometer prototype for cloud-height monitoring. Starting with a brief review of the ... -
Photonic crystal spatial filtering in broad aperture diode laser
(2019-10-02)
Article
Accés obertBroad aperture semiconductor lasers usually suffer from low spatial quality of the emitted beams. Due to the highly compact character of such lasers, the use of conventional intracavity spatial filters is problematic. We ... -
Reducing speckle in double-pass systems using focus tunable lenses
(2014)
Text en actes de congrés
Accés restringit per política de l'editorialSpeckle arises in double-pass systems when coherent light is reflected by the retina. Since it degrades the images that are used to characterize the eye, there is special attention in reducing speckle when working with ... -
Repeatability, reproducibility, and accuracy of a novel pushbroom hyperspectral system
(2013)
Article
Accés obert -
Sharp acoustic vortex focusing by Fresnel-spiral zone plates
(2018-05-14)
Article
Accés obertWe report the optimal focusing of acoustic vortex beams by using flat lenses based on a Fresnel- spiral diffraction grating. The flat lenses are designed by spiral-shaped Fresnel zone plates composed of one or several arms. ... -
Spherical refractive correction with an electro-optical iquid lens in a double-pass system
(2013-09-06)
Article
Accés obert -
Uso de técnicas de Inteligencia Artificial para la optimización de la potencia de lentes intraoculares para pacientes que sufren Cataratas
(Universitat Politècnica de Catalunya, 2021-07-09)
Treball Final de Grau
Accés obertEn este proyecto se pretende crear una red neuronal que optimice la posición de la lente efectiva en las operaciones de cataratas. Hoy en día para intentar averiguar la posición efectiva de la lente se siguen utilizando ...