An experimental campaign on joints of x-braced frames is presented. Tests are performed on strap-gusset joints and lower and upper corner joints. Many different phenomena and failure modes are observed in these tests. However, it is possible to see that only one failure mode can be accepted if a good seismic performance of the frame needs to be guaranteed: the net-section failure of the diagonal strap after yielding. The results of the tests also allow to establish a set of recommendations for seismic design of joints. The effectiveness of these recommendations is verified by means of two final tests on complete x-braced frames. A full explanation on the behaviour of the joints and frames tested is included, together with a description of the special test set-up developed for the experimental campaign.
CitationCasafont, M. [et al.]. Experimental testing of joints for seismic design of lightweight structures. Part 3: gussets, corner joints, x-braced frames. "Thin-walled structures", Juliol 2007, vol. 45, núm. 7-8, p. 637-659.
All rights reserved. This work is protected by the corresponding intellectual and industrial property rights. Without prejudice to any existing legal exemptions, reproduction, distribution, public communication or transformation of this work are prohibited without permission of the copyright holder. If you wish to make any use of the work not provided for in the law, please contact: firstname.lastname@example.org