Influence of cold work in the elastic modulus of the Ti-16.2Hf-24.8Nb-1Zr alloy characterized by instrumented nanoindentation
Visualitza/Obre
Article principal (5,276Mb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
10.4028/www.scientific.net/KEM.423.113
Inclou dades d'ús des de 2022
Cita com:
hdl:2117/6605
Tipus de documentArticle
Data publicació2010
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
Nowadays, β type Ti-based alloys have been developed for load transfer clinical
applications due to their superelasticity, shape memory effect, low elastic modulus and high
damping capacity [1]. These properties promote bone regeneration and make them promising
candidates for being used in load transfer implantology. The objective of the present work is to
achieve a material with shape memory properties and/or low elastic modulus. The influence of cold
work on the thermoelastic martensitic transformation and elastic modulus of the Ti-16.2Hf-24.8Nb-
1Zr alloy has been investigated to determine optimal conditions. The homogenized vacuum arc
melted button was heat treated at 1100ºC during 2 hours and quenched. Samples of each alloy were
microstructurally and mechanically characterized after being cold rolled from 5 up to 95%. The
elastic response for each condition was evaluated by instrumented nanoindentation by using a
Berkovich tip and a spherical tip. A decrease in elastic modulus was observed when increasing the
cold work percentage. The lowest value, 44 GPa, similar to that of cortical bone, was found in the
95% cold worked condition.
CitacióGonzález, M. [et al.]. Influence of cold work in the elastic modulus of the Ti-16.2Hf-24.8Nb-1Zr alloy characterized by instrumented nanoindentation. "Key engineering materials", 2010, vol. 423, p. 113-118.
ISSN1013-9826
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
KEM[1].423.113.pdf | Article principal | 5,276Mb | Accés restringit |