Time-domain electromagnetic interference measurement system for intermittent disturbances
Document typeConference report
PublisherInstitute of Electrical and Electronics Engineers (IEEE)
Rights accessRestricted access - publisher's policy
In Electromagnetic Compatibility emission measurements, a common problem takes place when equipment producing intermittent disturbances are measured according to standard procedures. In many cases, it is impossible to capture the maximum emission using conventional receivers with only one or several sweeps. A significant measurement improvement is possible when time-domain captures and post-processing implementing digital fast Fourier transform (DFT) is used to obtain the frequency spectrum. In addition, the time-domain method offers the possibility to capture all the spectrum frequency range of one single event and evaluate rapidly all the different functional modes of a complex EUT. In this paper, the time-domain method is described and validated for conducted emissions test. For the validation proposes, a multisine signal is measured using the developed method and the results are compared with results acquire from an EMI receiver. Finally, after validation, the time-domain method is applied to complex equipment observing the main advantages that the developed method provides.
CitationCosta, G. [et al.]. Time-domain electromagnetic interference measurement system for intermittent disturbances. A: International Symposium on Electromagnetic Compatibility. "2014 International Symposium on Electromagnetic Compatibility: September 1-4, 2014: Gothenburg, Sweden". Gotheborg: Institute of Electrical and Electronics Engineers (IEEE), 2014, p. 833-837.
|Time-Domain Ele ... ermittent disturbances.pdf||Time-Domain Electromagnetic Interference Measurement System for intermittent disturbances||301.6Kb||Restricted access|