Influence of the injection moulding parameters on the cellular structure and thermo mechanical properties of ethylene-propylene block copolymer and PETG foams
Visualitza/Obre
Arxiu principal (2,641Mb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Estadístiques de LA Referencia / Recolecta
Inclou dades d'ús des de 2022
Cita com:
hdl:2117/16802
Tipus de documentText en actes de congrés
Data publicació2012
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
Microcellular injection moulding technology is
capable of producing lightweight polymeric products.
Microcellular foams are characterised by cell densities in
the order of 109-1015 cells per cm3 and cell sizes between
10-100 μm in diameter. The foam morphology is
determined by the injection moulding parameters, and it
has been observed that depending on the parameters
variations, cell structure may exhibit substantial
morphological differences through the entire section,
along the melt flow direction of the injected part.
Using a constant temperature profile and blowing
agent dosage rate, variations of 3 key injection moulding
parameters (mould temperature, injection speed and shot
volume) were studied to analyse the effect on foam
morphology and thermal mechanical properties of single
ethylene-propylene block copolymer (EPBC) and
poly(ethylene glycol-co-cyclohexane- 1,4- dimethanol
therephthalate) (PETG) specimens.
CitacióArencon, D. [et al.]. Influence of the injection moulding parameters on the cellular structure and thermo mechanical properties of ethylene-propylene block copolymer and PETG foams. A: International Conference on Foams Materials & Technology. "FOAMS 2012". Barcelona: 2012.
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
Paper%2022_%20D%20Arenc%C3%B3n.pdf | Arxiu principal | 2,641Mb | Accés restringit |