Residual stresses and initial imperfections in non-linear analysis
Visualitza/Obre
1-s2.0-S014102961200449X-main.pdf (3,637Mb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
10.1016/j.engstruct.2012.08.013
Inclou dades d'ús des de 2022
Cita com:
hdl:2117/16636
Tipus de documentArticle
Data publicació2013-01
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
When non-linear finite element analysis (FEA) of cold-formed thin-walled steel sections subject to compression
is carried out, an initial perturbation must be introduced in the model in order to trigger the failure
due to instability. The most usual way is to introduce an equivalent initial imperfection in the model
(conventional models) that includes the effects of geometric imperfections and residual stresses due to
the roll-forming manufacturing process, possible loading eccentricity, etc. It is thought that results would
be more accurate if the actual measured geometric imperfections and the actual residual stresses induced
from manufacturing were introduced. This paper presents the determination of residual strains and stresses
generated in the cold roll-forming process of a typical rack section (without perforations) from steel
sheet, using FE simulation. The obtained residual elastic and plastic strains have then been incorporated
in the model, and used as an initial strain state in the non-linear finite element analysis. The results
obtained agree well with the experimental results for short and intermediate length columns, where
the failure mode is predominately local and distortional.
CitacióPastor, M. [et al.]. Residual stresses and initial imperfections in non-linear analysis. "Engineering structures", Gener 2013, vol. 46, núm. January, p. 493-507.
ISSN0141-0296
Versió de l'editorhttp://www.sciencedirect.com/science/journal/01410296
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
1-s2.0-S014102961200449X-main.pdf | 3,637Mb | Accés restringit |