Variation of roughness and adhesion strength of deposited apatite layers on titanium dental implants
Visualitza/Obre
Variations of roughness and adhesion strength of deposited apatite layers on titanium dental implants.pdf (716,9Kb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Cita com:
hdl:2117/13192
Realitzat a/ambUniversity of Minnesota School of Dentistry
Tipus de documentArticle
Data publicació2011-03-12
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
It is known that surface roughness and chemical composition of the titanium surface influence the osseointegration of titanium implants. Most commercial dental implants offer a shot-blasted rough surface. It
is also known that apatite layers coating the surface of titanium implants improve bone response, but the adhesion of the layer to the substrate poses some problems. In this study the roughness and adhesion strength to a titanium dental implant surface of an apatite layer deposited via wet chemistry after a thermochemical treatment were compared with those of plasma-sprayed apatite layers and machined titanium surfaces. Different surface conditions have been studied: (a) as-received machined dental implant surface; (b) grit-blasted titanium surface; (c) grit-blasted and thermochemicallytreated titanium surface; (d) titanium surfaces coated with plasma-sprayed apatite. The morphology and
roughness of the samples were measured and compared. The adhesion of the apatite layers to the titanium was compared by means of a scratch test. Measured roughness showed that the deposition of an apatite layer did not affect roughness but plasmasprayed apatite produced a decrease on roughness values when compared to control samples. Both roughness
and adhesion strength of the deposited apatite layer to the titanium substrate were higher than those of the plasma-sprayed apatite.
CitacióAparicio, C.; Rodriguez, D.; Gil, F.J. Variation of roughness and adhesion strength of deposited apatite layers on titanium dental implants. "Materials science and engineering C. Biomimetic and supramolecular systems", 12 Març 2011, vol. 31, núm. 2, p. 320-324.
ISSN0928-4931
Versió de l'editorhttp://www.sciencedirect.com/science/article/pii/S0928493110002365
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
Variations of r ... tanium dental implants.pdf | 716,9Kb | Accés restringit |