Measurement errors in multifrequency bioelectrical impedance analyzers with and without impedance electrode mismatch.
Visualitza/Obre
Measurement errors in multifrequency.pdf (401,3Kb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Cita com:
hdl:2117/7740
Tipus de documentArticle
Data publicació2009-06-03
Condicions d'accésAccés restringit per decisió de l'autor
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
The purpose of this study is to compare measurement errors in two commercially available multi-frequency bioimpedance analyzers, a Xitron 4000B and an ImpediMed SFB7, including electrode impedance mismatch.
The comparison was made using resistive electrical models and in ten human volunteers. We used three different electrical models simulating three different
body segments: the right-side, leg and thorax. In the electrical models, we tested the effect of the capacitive coupling of the patient to ground and the skin–electrode impedance mismatch. Results showed that both sets of equipment are optimized for right-side measurements and for moderate skin–electrode impedance mismatch. In right-side measurements with mismatch electrode, 4000B is more accurate than SFB7. When an electrode impedance mismatch was simulated, errors increased in both bioimpedance analyzers and the effect
of the mismatch in the voltage detection leads was greater than that in current
injection leads. For segments with lower impedance as the leg and thorax, SFB7 ismore accurate than 4000B and also shows less dependence on electrode mismatch. In both devices, impedance measurements were not significantly affected (p > 0.05) by the capacitive coupling to ground.
CitacióBogonez, F. [et al.]. Measurement errors in multifrequency bioelectrical impedance analyzers with and without impedance electrode mismatch.. "Physiological measurement", 03 Juny 2009, vol. 30, núm. 7, p. 573-587.
ISSN0967-3334
Versió de l'editorhttp://iopscience.iop.org/0967-3334/30/7/004/
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
Measurement errors in multifrequency.pdf | 401,3Kb | Accés restringit |