Noise reduction in AC-coupled amplifiers
Visualitza/Obre
06728674.pdf (623,0Kb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Cita com:
hdl:2117/26329
Tipus de documentArticle
Data publicació2014-07-01
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
AC-coupled amplifiers are noisier than dc-coupled amplifiers because of the thermal noise of the resistor(s) in the ac-coupling network and the increased contribution of the amplifier input noise current i(n). Both contributions, however, diminish if the corner frequency f(c) of the high-pass filter observed by the signal is lowered, the cost being a longer transient response. At the same time, the presence of large resistors in the ac-coupling network suggests that the use of FET-input amplifiers will be advantageous because i(n) is smaller than in bipolar amplifiers. However, the noise floor, defined as that for a dc-coupled amplifier, can be larger for FET-input amplifiers because of their higher input voltage noise. Therefore, there is no clear criterion to decide which amplifier type is quieter. In this paper, we propose the quotient between the high-pass frequency of the signal bandwidth (f(L)) and f(c) (K = f(L)/f(c)) as quantitative design parameter to reduce the additional noise contributed by a first-order ac-coupling network as compared with dc coupling. Using this parameter noise is greatly reduced without unnecessarily lengthening the transient response that results from the use of common qualitative design criteria. We demonstrate that relatively large K values yield total noise closer to the noise floor, hence it is better not to determine f(L) at the front amplifier stage but later on in the signal chain. Furthermore, a large K value permits bipolar op-amps to achieve lower noise than FET amplifiers even for capacitive signal sources, provided amplifier biasing is guaranteed.
CitacióSerrano, R.; Pallàs-Areny, R. Noise reduction in AC-coupled amplifiers. "IEEE transactions on instrumentation and measurement", 01 Juliol 2014, vol. 63, núm. 7, p. 1834-1841.
ISSN0018-9456
Versió de l'editorhttp://ieeexplore.ieee.org/xpl/articleDetails.jsp?arnumber=6728674
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
06728674.pdf | 623,0Kb | Accés restringit |