Friction coefficients and wear rates of different orthodontic archwires in artificial saliva
Visualitza/Obre
Article principal (331,1Kb) (Accés restringit)
Sol·licita una còpia a l'autor
Què és aquest botó?
Aquest botó permet demanar una còpia d'un document restringit a l'autor. Es mostra quan:
- Disposem del correu electrònic de l'autor
- El document té una mida inferior a 20 Mb
- Es tracta d'un document d'accés restringit per decisió de l'autor o d'un document d'accés restringit per política de l'editorial
Cita com:
hdl:2117/19153
Tipus de documentArticle
Data publicació2013-05
EditorSpringer
Condicions d'accésAccés restringit per política de l'editorial
Tots els drets reservats. Aquesta obra està protegida pels drets de propietat intel·lectual i
industrial corresponents. Sense perjudici de les exempcions legals existents, queda prohibida la seva
reproducció, distribució, comunicació pública o transformació sense l'autorització del titular dels drets
Abstract
The aim of this paper is to analyze the influence
of the nature of the orthodontic archwires on the friction
coefficient and wear rate against materials used commonly as
brackets (Ti–6Al–4V and 316L Stainless Steel). The mate-
rials selected as orthodontic archwires were ASI304 stainless
steel, NiTi, Ti, TiMo and NiTiCu. The array archwire’s
materials selected presented very similar roughness but
different hardness. Materials were chosen from lower and
higher hardness degrees than that of the brackets. Wear tests
were carried out at in artificial saliva at 37
C. Results show a
linear relationship between the hardness of the materials and
the friction coefficients. The material that showed lower
wear rate was the ASI304 stainless steel. To prevent wear,
the wire and the brackets have high hardness values and in
the same order of magnitude.
CitacióAlfonso, M. [et al.]. Friction coefficients and wear rates of different orthodontic archwires in artificial saliva. "Journal of materials science: materials in medicine", Maig 2013, vol. 24, núm. 5, p. 1327-1332.
ISSN1573-4838
Versió de l'editorhttp://link.springer.com/article/10.1007/s10856-013-4887-4
Col·leccions
Fitxers | Descripció | Mida | Format | Visualitza |
---|---|---|---|---|
10.1007_s10856-013-4887-4.pdf | Article principal | 331,1Kb | Accés restringit |